Introduction; Summary; About This Guide - HP ® xw9400 Setup Manual

With autodesk effects or editing 2008 application

Hide thumbs Also See for HP® xw9400:

Table of Contents

This guide describes how to set up the HP® xw9400 workstation for your Autodesk® Effects or

Editing 2008 application.

If you already own an HP xw9400 workstation shipped with the 2007 release of your Effects or

Editing application, you do not need to change its configuration. But, you do need to verify its

BIOS and firmware settings. See

Use this guide in conjunction with the Software Installation Guide for Linux Workstations, the

Configuration File Reference Guide for Linux® Workstations, the Stone Direct Configuration

Guide, and the Stone and Wire Filesystem and Networking Guide to install and configure the

hardware and software components of your Effects or Editing products.

In most cases, both hardware setup and application installation is done on delivery by an

OTE

authorized technician, so you may not need to perform some of the procedures in these guides.

The latest versions of all guides are available in PDF format from the Web at

http://www.autodesk.com/discreet-documentation. Use XPDF or Adobe® Acrobat® Reader™ to

view and print the PDF files.

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

"BIOS and Firmwares"

Introduction

. . . . . . . . . . . . . . . . . 3

on page 7.

Table of Contents