Wiring Your Video Components - HP ® xw9400 Setup Manual

3
Setting Up Video Hardware
Altinex® DA1804NT video distribution amplifier — The Altinex video distribution
amplifier can serve up to four video hardware devices from a single sync source/generator. It
serves the sync signal to the NVIDIA graphics board, the AJA OEM-2K board, and the Miranda
2
DVI-Ramp .

Wiring Your Video Components

Use this section to connect an HP xw9400 workstation equipped with an AJA OEM-2K board
and Miranda DVI-Ramp
Note the following about the wiring diagram:
•
Do not use an SD (NTSC or PAL) sync generator for HD projects. Always use a tri-level sync
generator for HD projects. Using the wrong sync generator for a project may impact the
stability of your workstation.
•
The sync source is connected to the Altinex video distribution amplifier. It is critical to
connect the Altinex distribution amplifier exactly as shown in the diagram to ensure the sync
works correctly.
•
The VTR is connected to the SDI In A and SDI Out A ports of the AJA breakout box. You can
use the SDI In B and SDI Out B ports for dual link video I/O.
•
VTR control is provided through the RS-422 port on the AJA breakout box.
24
2
for video I/O.