HP ® xw9400 Setup Manual page 15

BIOS Menu
Advanced
I/O
W :
Before installing Red Hat 4 Update 3, validate the BIOS Settings.
ARNING
Restoring BIOS to Default Factory Settings
If there is any doubt about whether items contain factory default values, the following
procedure restores default factory settings.
To restore default factory BIOS settings:
Press F10 while booting the workstation to enter the system BIOS.
1.
From the File menu, select Default setup | Restore Factory Settings as
2.
Default.
Press F10 to accept the changes.
3.
4. Select Apply Defaults and Exit.
This restores the original factory system defaults.
DVI-Ramp Firmware
System configuration is done prior to delivery by an authorized technician. The following
procedures may not be necessary, and are provided here for informational purposes only.
Item
Boot Order, Hard Drive
OS Power Management, ACPI S3
Support
Chipset / Memory, ECC Support Enabled
Chipset / Memory, Memory
Scrubbing
Chipset / Memory, Memory
Node Interleave
Chipset / Memory, PCI Serr#
Generation
Chipset / Memory, Net
Watchdog Timer
Chipset / Memory, ACPI Bus
Segmentation
Chipset / Memory, HPET
Device Options, S5 Wake on LAN Disabled
BIOS and Firmwares
Value
Integrated SATA
Integrated IDE
Disabled
Enable
Enable
Enable
Enable
Disabled
Enabled
9