Freezer Drawer - Frigidaire 242291901 Use & Care Manual

Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left sides (two screws on each side).
Remove Hex
Head Drawer
Screw
/
Remove Hex
Head Di
Screw
Do not remove center screw from freezer
drawer. This is a factory adjustment.
Remove Hex
Head Drawer
Screw
k
Remove Hex
Head Drawer
Screw
Drawer is heavy. Use caution when lifting.
........................................................................................................................................................................ " u_ _n8 ou_ _oremove: .......
Installing Freezer Drawer
1 With lower slides pulled out, hang drawer
onto slide brackets ensuring pins on each
side are fully inserted into slots on each side,
Fully Exten d
Drawer Slid _s
= 0 _Cabinet
Slo
Reinstall four drawer screws (two per
side), tighten down, and close drawer (C).
(2) Each Sid_
3 Check gasket seal around top, bottom,
and sides of freezer drawer.
4 If gasket is not sealed, open drawer and
slightly loosen four drawer screws (two on
each side) to allow drawer to rotate.
5 Close drawer and recheck the seal on the
gasket (A). Open the drawer grabbing by
the sides in the center (B). Be careful not
to rotate the drawer.
Push ............................................
Against
Freezer
Drawer
6 Tighten four drawer screws.
7 Recheck gasket seal.
8 Install the toe grille by fitting into place.