Table of Contents
Advertisement
INSTALLATION
Leveling Freezer Drawer
(if necessary)
1 Check gasket seal around top, bottom,
and sides of freezer drawer.
2 If gasket is not sealed, open drawer and
slightly loosen four drawer screws (two on
each side) to allow drawer to rotate.
3 Close drawer and recheck the seal on the
gasket (A). Open the drawer grabbing by
the sides in the center (B). Be careful not
to rotate the drawer.
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
4 Tighten four drawer screws.
5 Recheck gasket seal.
Push
Against
Freezer
Drawer
A
Level Refrigerator & Adjust Doors
(if necessary)
Guidelines for final positioning of your
refrigerator:
• All four corners of the cabinet must rest
firmly on the floor.
• The sides should tilt ¼ inch (6 mm) from
front to back (to ensure that doors close
and seal properly).
• Doors should align with each other and be
level.
Most of these conditions can be met by raising
or lowering the adjustable front rollers.
6
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Remove Hex
Head Drawer
Screw
Grab Drawer
At Center
From Both
Sides Then
Pull Drawer
Out
B
To level the cabinet using the front
rollers (select models):
1 Slightly open freezer drawer. Lift the
toe grille and gently pull forward (see
illustration).
2 You can raise or lower each door. Use a ⅜
inch socket wrench to turn the adjustment
screws (one per side).
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(3) Retaining Clips
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw
counterclockwise.
3 Ensure both doors are bind-free with their
seals touching the cabinet on all four sides
and that cabinet is stable.
4 After unit is leveled, lower anti-tip leg until
it contacts the floor.
Door
Anti-tip
Leg
5 Install the toe grille by fitting into place.
Door
Raise
Lower
Advertisement
Table of Contents
