Locating The Filters; Replacing The Water Filter; Ordering Replacement Filters; More About Your Advanced Water Filter - Frigidaire 242291901 Use & Care Manual

Locating the Filters
Your refrigerator is equipped with water filtering
system. The water filter system filters all
dispensed drinking water, as well as the water
used to produce ice.
Water Filter
The water filter is located at the top right side
of the flesh food compartment.
Replacing the Water Filter
]:n general, you should change the water filter
every six months to ensure the highest possible
water quality. Water Filter Status on the user
interface prompts you to replace the filter after
a standard amount of water (200 gallons/757
liters for PureSource Ultra
TM)
has flowed
through the system.
]:f your refrigerator has not been used for a period
of time (during moving for example), change the
filter before reinstalling the refrigerator.
Filter Cartridc
Ordering Replacement Filters
To order your replacement filters, please visit
our online store at www.fligidaire.com/store,
by calling toll-free at 877-808-4195, or by
visiting the dealer where you purchased your
refrigerator. Frigidaire recommends that you
order extra filters when you first install your
refrigerator, and that you replace your filters at
least once every six months.
Here is the product number to request when
ordering:
PureSource Ultra
TM
Water Filter
Part #ULTRAWF
When ordering your replacement filter,
please reorder the same filter type that is
currently in your refrigerator.
More about your Advanced
Water Filter
_S_ IThe PureSource Ultra
TM
ice and I
[water filter system is tested and [
Icertified to NSF/ANSI Standards 42 and I
Is3
for the reduction of daims specified I
..... [on the performance data sheet. [
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
Test & certification results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra
TM
ice and water filter
• Rated service flow - .50 gallons per minute
• Operating Temp: Min. 33 ° F, Max. 100 ° F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace your PureSource Ultra
TM
water
filter:
]:t is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the
filter replacement.
1 Turn Off the ice maker power switch.
2 Remove the filter by pushing on the end/face
of the filter.
3 Slide the old water filter cartridge straight out
of the housing and discard it.
4 Unpackage the new filter cartridge. Using
the alignment guide, slide it gently into the
filter housing until it stops against the snap-in
connector at the back of the housing.
5 Push firmly until the cartridge snaps into
place (you should hear a click as the cartridge
engages the snap-in connector).
6 Press a drinking glass against the water
dispenser while checking for any leaks at the
filter housing. Any spurts and sputters that
occur as the system purges air out of the
dispenser system are normal.
7 After filling one glass of water, continue
flushing the system for about four minutes.
8 Turn On the ice maker.
Press and hold the Water Filter button on the
Ice & Water Dispenser control panel for three
seconds. When the display changes from Red
to Green, the status has been reset.