Leveling Freezer Drawer; Level Refrigerator - Frigidaire LGHN2844MP5 Use & Care Manual

Leveling Freezer Drawer (if
necessary)
1 Check gasket seal around top, bottom,
and sides of freezer drawer.
2 If gasket is not sealed, open drawer and
slightly loosen four (4) drawer screws
(two (2) on each side) to allow drawer to
rotate.
3 Close drawer and recheck the seal on the
gasket (A). Open the drawer grabbing by
the sides in the center (B). Be careful not
to rotate the drawer.
Remove Remove
hex head
head
d rawer d rawer
screw screw
To level the cabinet using the front
rollers (select models):
1 Slightly open freezer drawer. Lift the
toe grille and gently pull forward (see
illustration).
2 You can raise or lower each door. Use
a 3/s inch socket wrench to turn the
adjustment screws (1 per side).
Toe Grille Must
'Remove
Hex Hex
Head ....... Head
Drawer Drawer
Screw Screw
4 Tighten four (4) drawer screws.
5 Recheck gasket seal.
Push
Against
Freezer
Level Refrigerator & Adjust
Doors (if necessary)
Guidelines for final positioning of your
refrigerator:
= All four corners of the cabinet must rest
firmly on the floor.
The sides should tilt 1/4 inch (6 mm) from
front to back (to ensure that doors close
and seal properly).
Doors should align with each other and be
level.
Host of these ¢ond_ons can be met by raising
or lowering the adjustable front rollers.
To raise: turn adjustment screw
clockwise.
To lower: turn adjustment screw
counterclockwise.
3 Ensure both doors are bind-free with their
seals touching the cabinet on all four sides
and that cabinet is stable.
4 After unit is leveled, lower anti-tip leg until
it contacts the floor.
\J
Raise
5 Install the toe grille by fitting into place.