Frigidaire 242291901 Use & Care Manual page 15

Door Handle Hounting
Instructions for
Frigidaire Professional +
1 Remove handles from carton
and any other protective
packaging.
Position fresh food handle
end over upper and lower
pre-instailed shoulder bolts
(A) that are fastened into
door, ensuring the holes for
the set screws are facing
towards the opposite door.
While holding handle firmly
against door, fasten upper
and lower Allen set screws
(B) with supplied Allen
wrench.
Repeat steps 2 and 3 to install
opposite handle. Ensure the
holes for the set screws are
facing towards the first door.
Position freezer handle end
over left and right pre-
installed handle mounts that
are fastened to the door,
ensuring the holes for the set
screws are facing down.
While holding handle firmly
against door, loosely tighten far
right Allen set screw (B) with
supplied Allen wrench until
there is no gap between handle
and door.
Still holding the handle firmly to
the door, firmly tighten far left
Allen set screw (B) with supplied
Allen wrench.
Re,am to the far right Allen set
screw (B) and firmly tighten
with supplied Allen wrench.
Firmly tighten the inside Allen
set SCreWS.
Mounting Refrigerator Handles
Mounting Freezer Handle
All set screws should be tightened so the screw is below
the surface of the handle. The handles should be drawn
tight to freezer and refrigerator doors with no gaps.
Opening the opposite door while tightening the Allen
screw makes installation easier.
The door handle may loosen over time or if it was
installed improperly. If this happens, tighten the set
screws on the handles.
Wear gloves andsafetygoggles.UseextremeCAUTION when installingthese handles.