Cisco uBR10012 Software Configuration Manual page 27

Chapter 1 Overview of Cisco uBR10012 Universal Broadband Router Software
Tip The Fast Ethernet interface on the backup PRE module is not used unless the primary PRE module
fails and the backup PRE module is activated. When the backup PRE module becomes the active PRE
module, its FastEthernet interface automatically becomes the active FastEthernet interface at slot 0/0.
Figure 1-2
corresponding slot numbering.
Figure 1-2
OL-1520-05
shows the rear view components of a fully loaded Cisco uBR10012 router with the
Cisco uBR10012 Router Slot Numbering—Rear View
CI SC O
CI SC O
10 00 0
10 00 0
Cable interface slot 5/1
Cable interface slot 5/0
Cable interface slot 6/1
Cable interface slot 6/0
Cable interface slot 7/1
Cable interface slot 7/0
Cable interface slot 8/1
Cable interface slot 8/0
Cisco uBR10012 Universal Broadband Router Software Configuration Guide
Cisco uBR10012 Universal Broadband Router Chassis Overview
TCC+ card slot 1/1
TCC+ card slot 2/1
CI SC O
CI SC
10 00 0
10 0
Uplink line card slot 4/0
Uplink line card slot 3/0
Uplink line card slot 2/0
Uplink line card slot 1/0
1-7