Show Interface Cable - Cisco uBR10012 Software Configuration Manual

Chapter 6 Troubleshooting the System

show interface cable

To display the current configuration and status of a cable interface, use the show interface cable
command in privileged EXEC mode.
show interface cable slot/port [options]
Syntax Description slot/port
options
Examples
The following example displays show interface cable command output for a CM located in slot 1 and
port 0:
Router# show interface cable 5/0/0
Cable5/0/0 is up, line protocol is up
Hardware is BCM3210 FPGA, address is 00e0.1e5f.7a60 (bia 00e0.1e5f.7a60)
Internet address is 1.1.1.3/24
MTU 1500 bytes, BW 27000 Kbit, DLY 1000 usec, rely 255/255, load 1/255
Encapsulation, loopback not set, keepalive not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 4d07h, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Queuing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
OL-1520-05
Identifies the Cisco CMTS chassis slot number and downstream port number.
Cable-specific options are documented in their own command reference pages in the
Cisco Broadband Cable Command Reference Guide
10908 packets input, 855000 bytes, 0 no buffer
Received 3699 broadcasts, 0 runts, 0 giants, 0 throttles
3 input errors, 3 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
5412 packets output, 646488 bytes, 0 underruns
0 output errors, 0 collisions, 13082 interface resets
0 output buffer failures, 0 output buffers swapped out
Cisco uBR10012 Universal Broadband Router Software Configuration Guide
show interface cable
on Cisco.com.
6-9