Rear Panel - Sony LMD-1541W Operating Instructions Manual

Rear Panel

1
2
3
a SDI (3G/HD/SD) input and output connectors
(BNC)
1 (input) connector, 2 (input) connector
Input connector for serial digital component signals.
SDI 1 and SDI 2 inputs are available.
OUT connector
Output connector for serial digital component signals.
Notes
• The signal from the OUT connector does not satisfy
the ON-LINE signal specifications.
• Output is only activated when the power is on. No
output in standby mode.
b COMPOSITE input and output connectors
(BNC)
IN connector
Input connector for composite video signals.
OUT connector
Loop-through output connector.
Note
When inputting a video signal with the jitters, etc. the
picture may be disturbed. We recommend using the
TBC (time base corrector).
c AUDIO input and output connectors (stereo
mini jack)
IN connector
Connect to the audio outputs of external equipment
such as a VCR.
OUT connector
Outputs the audio signal which is selected by the input
select button on the front panel.
When SDI signal is selected, either the audio signal of
the channel which is selected in AUDIO SETTING of
SDI
OUT
COMPOSITE
IN OUT
AUDIO
IN OUT
IN
PARALLEL SERIAL
REMOTE REMOTE
4 5 6 7 8 9
the USER CONFIG menu or the audio signal from the
AUDIO IN connector is output.
d PARALLEL REMOTE connector (modular
connector, 8-pin)
Forms a parallel switch and controls the monitor
externally.
For details on the pin assignment and factory setting
function assigned to each pin, see page 39.
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
e SERIAL REMOTE connector (RJ-45)
Connect to the network or Sony BKM-15R/16R
Monitor Control Unit by using a 10BASE-T/100BASE-
TX LAN cable (shielded type, optional).
For details, refer to the Interface Manual for
Programmers (saved in the supplied CD-ROM,
Japanese and English only).
CAUTION
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
• When you connect the LAN cable of the unit to
peripheral device, use a shielded-type cable to prevent
malfunction due to radiation noise.
• The connection speed may be affected by the network
system. This unit does not guarantee the
communication speed or quality of 10BASE-T/
100BASE-TX.
Location and Function of Parts and Controls
13