Sony LMD-1541W Operating Instructions Manual page 27

Submenu Setting
SD PIXEL MAPPING Selects SD picture size (pixels)
according to the input signal format
from the COMPOSITE IN
connector.
When picture signals in the size
of 720 × 576 (50i) (or 720 × 487
(60i)) are input
When picture signals in the size
of 702 × 576 (50i) (or 712 × 483
(60i)) or equivalent are input
MARKER SETTING
USER CONFIG – MARKER SETTING
M A R K E R E N A B L E :
M A R K E R S E L E C T :
C E N T E R M A R K E R :
S A F E T Y A R E A :
M A R K E R L E V E L :
M A R K E R M AT :
Submenu Setting
MARKER ENABLE Selects ON to display the marker
and OFF not to display.
Note
When NATIVE is selected in the
SCAN setting, the marker is not
displayed.
To display the marker, select a
setting other than NATIVE.
MARKER SELECT Selects the aspect ratio according to
the film, when the frame of the film
is displayed on the screen.
When 16:9 aspect ratio is selected
with the button which the aspect
function is assigned
When 4:3 aspect ratio is selected
with the button which the aspect
function is assigned
Select 720 × 576 (or 720 ×
487). This is the default
setting.
When 702 × 576 (or 712 ×
483) is selected, all sides of
the input picture are cut off
by several pixels.
Select 702 × 576 (or 712 ×
483).
When 720 × 576 (or 720 ×
487) is selected, a black
border (of several pixels
wide) appears around the
input picture.
xxx
xxx
xx
xxx
x
xxx
You can select from among
4:3, 15:9, 14:9, 13:9, 1.85:1,
2.35:1, 1.85:1 & 4:3 and
OFF.
You can select 16:9 or OFF.
Submenu Setting
CENTER MARKER Selects ON to display the center
mark of the picture and OFF not to
display.
SAFETY AREA Selects the safe area size for the
aspect ratio determined by the
button to which the aspect function
is assigned. You can select from
OFF, 80%, 85%, 88%, 90% and
93%.When the marker is displayed,
the safe area for the marker is
displayed.
MARKER LEVEL Sets the luminance to display the
MARKER SELECT, CENTER
MARKER and SAFETY AREA.
You can select from among 1 to 3.
When the setting is low, the marker
appears dark.
MARKER MAT Selects whether you put mat on the
outside of the marker display.
• OFF: No mat is put.
• HALF: Gray mat is put.
• BLACK: Black mat is put.
T/C (time code) DISPLAY SETTING
USER CONFIG – T/C DISPLAY SETTING
T / C :
F O R M AT :
P O S I T I O N :
T R A N S PA R E N C Y:
Submenu Setting
T/C Selects ON to display the time code
display and OFF not to display.
FORMAT Sets the time code format.
• VITC: To display the time code
• LTC: To display the time code in
POSITION Sets the position of the time code
display. You can select between 1
and 2.
• 1: Top
• 2: Bottom
Note
Settings cannot be changed when
IMD is activated. The POSITION
setting in IMD SETTING has a
priority over that in T/C DISPLAY
SETTING when the same settings
are made in the two menus.
xxx
xxx
x
xxxx
in VITC format.
LTC format.
27
Adjustment Using the Menus