Display Of Atmospheric Conditions; Holdover Display - Leica Rangemaster CRF 1600 Instructions Manual

DISPLAY OF ATMOSPHERIC CONDITIONS

For accurate calculation of the impact point (see
following section), the LEICA RANGEMASTER CRF
1600 also determines three of the most important
general conditions when measuring the range: the
inclination of the unit, the temperature and the
atmospheric pressure. You can display the relevant
values at any time.
To do this, briefly press the secondary button (1)
when the target mark or the range is displayed.
• Below the target mark (or instead of the range), the
following will appear in turn for around 2 seconds
each:
– Angle of inclination
– Temperature
– Atmospheric pressure

HOLDOVER DISPLAY

If required, the LEICA RANGEMASTER CRF 1600 will
display the corresponding holdover after the mea-
sured range. When used for hunting/shooting, this
enables the unit to provide valuable information for
the shooter in firing the most accurate shot possi-
ble. In addition to the range, the calculation is based
on the general conditions discussed in the previous
section and the ballistic curve you have specified.
Notes:
• The displayed holdover value / correction value
(see also p. 31) is always shown in cm for a range
of 100 m or in inches for 100 yards.
The correction value for the range actually measured
is automatically converted to 100 m/100 yds. The
major advantage of this is that the correction value
can be set directly on the riflescope, i.e. without
elaborate prior conversion.
28