Table of Contents
Advertisement
Back to Contents Page
Hinge Cover
Dell™ Latitude™ D620 Service Manual
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE:
The hinge cover is fragile and can be damaged if extreme force is used. Be careful when removing the hinge cover.
1. Follow the procedures in
Before You
2. Turn the computer top-side up, and then open the display all the way (180 degrees) so that the display rests on your work surface.
NOTICE:
To avoid damaging the hinge cover, do not lift the cover on both sides simultaneously. Removing the hinge cover in a different way than
described may cause the plastic to break.
1
hinge cover
3. Starting on the right side of the computer, use a plastic scribe to pry up the hinge cover. Lift the cover away from the computer going from the right
toward the left, and lay the cover aside.
Before installing the hinge cover, ensure that all cables are routed correctly. Improper routing of the cables can cause damage to the cables.
4. To replace the hinge cover, insert the left edge of the cover into place.
5. Press from left to right until the cover snaps into place.
Back to Contents Page
Begin.
2
plastic scribe
3
indent
Advertisement
Table of Contents
