Table of Contents
Advertisement
Installing the Processor Module
NOTICE:
Ensure that the cam lock is in the fully open position before seating the processor module. Seating the processor module properly in the ZIF
socket does not require force.
NOTICE:
A processor module that is not properly seated can result in an intermittent connection or permanent damage to the processor and ZIF
socket.
1. Align the pin-1 corner of the processor module so that it points to the triangle on the system board, and insert the processor module into the ZIF socket.
When the processor module is correctly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than the
others, the module is not seated correctly.
NOTICE:
Hold the processor down while turning the cam screw to prevent intermittent contact between the cam screw and processor.
2. Tighten the ZIF socket by turning the cam screw clockwise to secure the processor module to the system board.
3. Peel the backing off the thermal cooling pad and adhere the pad to the portion of the thermal-cooling assembly that covers the processor.
4. Replace the processor thermal-cooling assembly (see
5. Replace the palm rest (see
6. Replace the coin-cell battery (see
7. Replace the keyboard (see Keyboard).
8. Replace the optical drive (see
9. Replace the hinge cover (see
10. Replace the battery.
11. Update the BIOS using a flash BIOS-update program CD. See
Back to Contents Page
Processor Thermal-Cooling
Palm
Rest).
Coin-Cell
Battery).
Media Bay
Devices).
Hinge
Cover).
Assembly).
Flashing the BIOS From a
CD.
Advertisement
Table of Contents
