Troubleshooting; Wiring Diagram - Pacific hydrostar Portable Sprinkler Pump Manual

troubleshooting

Problem
Motor will not 1. Cord not connected.
start.
2. No power at outlet.
3. Fuse is blown or breaker tripped.
4. Internal damage or wear. (Carbon
brushes or switch, for example.)
Motor runs 1. Improper priming.
but water isn't
2. Clogged filter at end of intake
pumping.
connections.
3. Discharge valve closed.
4. Pipe size too small.
5. Impeller plugged.
6. Pipes frozen.
Pump does not 1. Corroded pipes.
deliver water at
2. Piping size too small.
full capacity.
3. Not enough water supplied to Pump.
4. Low Voltage.
Excessive noise Internal damage or wear. (Carbon
or rattling. brushes or bearings, for example.)
Follow all safety precautions whenever diagnosing or servicing the tool. disconnect power
supply before service.

Wiring diagram

Page 6
Possible causes
For technical questions, please call 1-800-444-3353.
likely Solutions
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered, turn off
tool and check circuit breaker. If breaker is tripped,
make sure circuit is right capacity for tool and circuit
has no other loads.
3. Have fuse replaced by a qualified service technician.
4. Have serviced by a qualified service technician.
1. Re-prime according to directions.
2. Clean filter.
3. Open discharge valve.
4. Re-pipe using pipe of the same size as the Pump
inlet and outlet ports.
5. Have Impeller cleaned by qualified service technician.
6. Thaw pipes. Check for damage before using pump.
1. Replace pipes.
2. Re-pipe using pipe of the same size as the Pump
inlet and outlet ports.
3. Enlarge inlet pipe. Check well pump system.
4. Check that outlet is 120V.
Have technician service tool.
1 POWER CABLE
2 PRRESSURE SWITCH
3 TERMINAL
4 CAPACITOR
5 MOTOR
SKU 68421