Pacific hydrostar Portable Utility Pump 65836 Set Up And Operating Instructions Manual page 9

tool Set Up
From accidental
oPeration:
turn the Power Switch of the
tool to its "oFF" position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
1. This pump operates immediately
when plugged in. Do not plug in this
pump when dry. Always prime pump
before plugging in.
Work Piece and Work area Set Up
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
2. Route the power cord along a safe
route to reach the work area without
creating a tripping hazard or exposing
the power cord to possible damage.
The power cord must reach the work
area with enough extra length to al-
low free movement while working.
3. There must not be hazardous ob-
jects, such as utility lines or foreign
objects, nearby that will present a
hazard while working.
4. Protect yourself and others from
risk of electrical shock. Always wear
insulated boots and gloves. Stay out
of water or wet surfaces. Protect the
pump and its power cord from mois-
ture.
SKU 65836
to PreVent
SerioUS injUry
For technical questions, please call 1-800-444-3353.
5. Never operate this tool in explosive
atmospheres.
general operating instructions
1. Attach inlet and outlet hoses (not
included) to pump. Standard garden
hoses will work.
2. Attach accessory Basket Filter to inlet
end of inlet hose.
3. Place basket filter end of inlet hose in
water to be pumped.
4. Rout outlet hose so that pumped wa-
ter will run off appropriately.
5. Remove Priming Plug (4) by turn-
ing counterclockwise. Fill pump with
clean water. Replace Priming Plug by
turning clockwise.
6. Plug in Power Cord (22). Pump will
operate immediately. It will take a
few minutes for pump to prime and
remove air from inlet hose. Water
will then flow through the hoses and
pump.
7. Do not allow the Basket Filter to be-
come clogged. Check it periodically
to be sure that clear water can enter
the inlet hose.
8. Do not allow the pump to run dry.
Running dry, the pump will overheat,
and impeller and seals will be dam-
aged.
9. To prevent accidents, turn off the tool
and disconnect its power supply after
use. Clean, then store the tool in-
doors out of children's reach.
Page 9