Oki ML1120 User Manual page 65

PROBLEM
Too high or too low TOF
(where printing starts).
Too large or small left
and/or right margins.
When continuous forms
are used, the content of
a single form is printed
on two forms.
When cut sheets are
used, the content of a
single sheet is printed
on two sheets.
The content of a single
line is printed in two
lines.
When continuous forms
are used, several blank
lines appear in the
printout.
ML1120/ML1190 User's Guide – Troubleshooting > 65
CAUSE
The TOF is not correctly
selected.
The left or right margin
is not correctly
selected.
The paper length
selected in the
application does not
match the physical
paper length.
The paper setting
selected in the
application does not
match the physical
paper size.
It does not match the
lines per page as the
printer automatically
detected.
The left and/or right
margins are not
correctly selected.
Tear-off perforation
spacing is selected.
ACTION
Initialise the printer.
Select correct TOF for
cut sheet and
continuous forms.
Select the first-line print
position and adjust the
paper top position.
Reselect the margin
correctly in the
application.
Incorrect positions of
the Paper Guide or Pin
Tractors. Select and
adjust the position
again depending on the
paper type.
Reselect the left and
right margins correctly
in the application.
Match the paper length
selected in the
application with the
physical paper length in
use.
Match the paper setting
selected in the
application with the
physical paper in use.
Leave enough top and
bottom margin in the
application.
Correct the cut sheet LF
adjustment.
Reselect the left and
right margins correctly
in the application.
Cancel tear-off
perforation spacing.