Cisco CallManager Release 3.0(10 Specification page 96

Documentation Updates
Running Show Tech
Changes
Default Value Changed for SdlTraceTotalNumFiles Service Parameter
Omissions
Caution
Release Notes for Cisco CallManager Release 3.0(10)
96
To run show tech correctly, use this example to construct your command:
show -f output.txt -v -w480 db
The example given in the Show Command chapter of Configuring Remote
Serviceability for Cisco CallManager 3.0 (page 3-2) lacks a space before "db."
This section contains changes that have occurred since the original release of the
Cisco CallManager Administration Guide Release 3.0. These changes do not
currently appear in the Release 3.0 Cisco CallManager Administration Guide or
the online help for the Cisco CallManager application.
SdlTraceTotalNumFiles is a service parameter for the Cisco CallManager service
type. The default has been changed to 250. This is the correct default for this
service parameter.
This section contains lists of service parameters for the Cisco CallManager that
were not included in the initial production of the Release 3.0 Cisco CallManager
Administration Guide and online help for the Cisco CallManager application. A
later release of the document will define these parameters.
Do not modify any of the defaults or settings of the following
parameters without the assistance of the Cisco Technical Assistance
Center (TAC).
78-13493-02