1. Turn the Upper Filter Assembly 1/4turn counterclockwise
and lift out.
2. Grasp the Lower Filter in the circular opening, lift slightly, and pull forward to remove.
3. Clean the filters as shown below.
IMPORTANT: Do not usewire brush, scouring pad, etc., as they may damage the filters.
Rinse filter under running water until most soils are removed. If you
soils or calcium deposits from hard water, a
soft brush may be required.
Filter Reinstallation Instructions
1. Noting the previous illustrations, place the Lower Filter under the Locating Tabs in the
bottom of the dishwasher
so the round opening for the Upper Filter Assembly lines up
with the round opening in the bottom of the tub.
Insert the Upper Filter Assembly into the circular opening in the Lower Filter.
3. Slowly rotate the filter clockwise until it drops into place. Continue to rotate until the filter
is locked into place. If the filter is not fully seated (still turns freely), continue to turn the
filter clockwise until it drops and locks into place.
IMPORTANT: To avoid damage to dishwasher, do not operate your dishwasher without the ULTRACLEAN
filters properly installed.
Be sure the Lower Filter is securely in place and the Upper Filter Assembly is locked into place. If the Upper Filter Assembly turns
freely, it is not locked into place.
DISHWASHER EFFICIENCY TIPS
Hot water dissolves and activates the dishwasher detergent. Hot water also dissolves grease on dishes and helps glasses dry spot-
free. For best dishwashing
results, water should be 120°F (49°C) as it enters the dishwasher. Loads may not wash as well if the water
is too low.
To save water, energy and time, only scrape dishes. Do not rinse dishes before putting them into the dishwasher.
Use a delay feature to run your dishwasher during off-peak
hours. Local utility providers recommend avoiding
heavy usage of
energy at certain times of day.
During the summer, run your dishwasher at night. This reduces daytime
heat buildup in the kitchen.
Use a rinse aid to improve drying.