Electrical Requirements; Removing The Doors; Convertible Vegetable/M Eat Drawer Tern Perature Control; Crisper And Crisper Cover Cdsper Humidity Control - Kenmore 2206128 Use & Care Manual

Table of Contents

Advertisement

i i
ii ii
ii
Electrical Shock Hazard
Plug into a grounded
3 prong
outlet.
Do not remove
ground
prong.
Do not use an adapter.
Do not use an extension
cord.
Failure
to follow
these
instructions
can result in
death,
fire, or electrical
shock.
Before you move your refrigerator into its f_na[ location, it is
important to make sure you have the proper electrical
connection:
Recommended
grounding
method
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused, grounded
electrical supply is required, it is recommended
that a separate
circuit serving only your refrigerator be provided
Use an outlet
that cannot be turned off by a switch
Do not use an extension
cord
NOTE: Before performing any type of installation, cleaning, or
removing a light bu]b, turn the control
(Thermostat,
Refrigerator
or Freezer Control depending
on the mode{) to OFF and then
d_sconnect the refrigerator from the efectr{cal source, When you
are finished, reconnect the refrigerator to the electrical source
and reset the control (Thermostat,
Refrigerator or Freezer Controt
depending
on the mode_) to the desired setting,
Electrical Shock Hazard
Disconnect
power
before
removing
doors.
Failure
to do so can result in death
or
electrical
shock°
,, ,,,
................................
NOTE: Before removing doors, open both doors and remove
base grille (see the "Base Grille" section)
Tools Needed:
V4in hex-head socket wrench and _A6in hex-head socket
wrench.,
1.
Unplug refrigerator or disconnect
power.
2.
If you have a dispenser (ice or water), disconnect water line
(behind base gritle).
=
Remove hose from clip
a
Disconnect
union nut and slide it back onto tube.
=1 Remove metal insert from tube,
m Remove union nut and spring,
3.
Remove left top hinge,
=
Remove hinge cover screw and hinge cover
m Remove hinge screws. DO NOT REMOVE SCREW 6 AS
SHOWN IN DIAGRAM.
N
Disconnect
wiring ptug and both ground wires,
5
6
7
1, Hinge Cover Screw
2, Hinge Cover
3_ Hinge Piate Screws
4, Wiring Plug
5 Ground Wires
6 Do not remove this screw
Z Hinge Plate

Advertisement

Table of Contents
loading

This manual is also suitable for:

106

Table of Contents