Desa Comfort Glow CGCF26TN Owner's Operation And Installation Manual page 5

ASSEMBLY
Contmued
ASSEMBLING FIREPLACE
ToolsR_uired:Phillipsscrewdfiver, 5/16"hexwrenc_ andslottedscrewddver
Installing Log
I. Remove back log, branch, and hood from log box. Discard protective packaging.
2. Remove two shipping screws above screen (see Figure 2).
3. Lift screen up and pull out to remove.
4. An optional blower is available. See Accessories, page 32. Install optional
blower now. Follow installation instructions provided with blower.
5. Gently place back log on burner support (see Figure 2). The log should fit fiat
against top of burner support. Place two #10 one-inch-long screws through burner
support into the log and tighten. Place branches on branch support (see Figure 2).
6. Reattach screen by placing notches in screen frame over shoulder screws and
pushing down.
__ Shipping Screw Screw
Sack Log
12j _
Figure 2 - Assembling Fireplace
WARNING
Failure to position the parts in accordance with these diagrams or
failure to use only parts specifically approved with this fireplace may
result in property damage or personal Injury.
Assembling Hood
1. Lift screen off heater.
2. Remove two 1-3/4" screws from louver assembly (see Figure 2). Save these screws.
Upper
Louver
Assembly
I
Short
/
I
-- 1-3/4" Screws
Figure 3 - Assembling Hood
3. Pull louver assembly straight out from the cabinet. Be careful not to scratch the
paint. Set louver assembly and screws aside.
4. Locate two black Phillips sheet metal screws from the hardware packet.
5. Place hood over top edge of firebox wrappol".
6. Attach hood with two short screws in center of hoed.
7. Replace upper and lower assembly and 1-3/4" screws removed in step 2.
I