Desa Comfort Glow CGCF26TN Owner's Operation And Installation Manual page 17

1
lO3668
CONNECTING
TO GAS
SUPPLY
Continued
CONNECTING FIREPLACE TO GAS SUPPLY
Installation Items Needed
• Phillips screwdriver
• sealant (resistant to propane gas, not provided)
I. Remove fireplace screen. Remove two screws that hold fireplace screen in place
for shipping. These screws are located near top of screen. Discard screws. Lift
fireplace screen up and pull out to remove.
2. Remove screws that attach branch support to fireplace (see Figure 17). Care-
fully lift up branch support and remove from fireplace (see Figure 17).
Screen Shipping
Support I Screw
i • ,Few
zFlexible Gas Line
Figure 17-Removing Log Base Assembly From Fireplace
3. Route flexible gas line from manual shutoff valve into fireplace through side or rear
access holes in outer casing. Route flexible gas supply line through fireplace access
holes in outer casing.
NOTICE
Most building codes do not permit concealed gas
connections. A flexible gas line is provided to allow
accessibility from the fireplace, The flexible gas
supply line connection to the manual shutoff valve
should be accessible,
4. Apply pipe joint sealant lightly to male threads of gas connector attached to
flexible gas line (see Figure 18). Connect flexible gas line to flexible gas line
attached to gas regulator of fireplace (see Figure 18).
5. Check all gas connections for leaks. See.Checking Gas Connections, page 18.
6. Replace branch support back into fireplace. Feed flexible gas line into fireplace
base area while replacing branch support. Make sure the entire flexible gas line
is in fireplace base area. Reattach branch support to fireplace with screws
removed in step 3.
To Fireplace
Gas Gas Connector
Manual Shutoff Valve
Flexible Gas Line To Gas
from Fireplace Gas Supply
Regulator Flexible Gas Line from
Manual Shutoff Valve "_
FigiJre 18 - Attaching Flexible Gas Lines Together
Continued