Advertisement
Available languages
Available languages
l/sst®ll®tion
requiremen%
location
This appliance
must be installed
on firm flooring
to minimize
vibration
during
spin cycle. Concrete
flooring
is best, but
wood base is sufficient,
provided
floor
support
meets FHA
standards.
This appliance
should not be installed
on rugs or
exposed
to weather.
WATER PRESSURE - Must be 20 psi minimum
to 120 psi
maximum.
WATER TEMPERATURE - Household
water
heater should be
set to deliver
water
at 120 °F (50 °C) IN THE WASHER when
hot wash is selected.
SHUTOFF VALVES - Both hot and cold shutoff valves (fau-
cets) should be supplied.
DRAIN - Water
may be drained
into standpipe
or set tub.
Discharge
height MUST NOT BE LESS THAN 30 INCHES,
and no more than 8 feet above the base of the washer.
Standpipe
must be 1-1/2 inches minimum
inside diameter
and must be open to atmosphere.
IElectrical
requirements
CAUTION:
Before plugging
in washer, read the following
electrical
requirements.
CAUTION:
For personal
safety, do not use an extension
cord
or adapter
plug with this appliance.
Do not, under any cir-
cumstances,
cut or remove the third
grounding
prong from
the power cord. Follow national
electrical
codes and ordi-
nances. This appliance
must be supplied with the voltage
and
frequency
indicated
on the rating
plate (located
at the top
of the dryer front panel), and connected
to an individual,
properly
grounded
branch
circuit, protected
by a 15- or 20-
amp circuit breaker
or time-delay
fuse. If the electric
supply
provided
does not meet the above requirements,
call a li-
censed electrician.
Installation
Sequence
Step 1 Verify Your Gas Installation (see section 2).
Step 2 Prepare the Area and Exhaust for Installation of ap-
Step 3
Step 4
Step 5
Step
Step
pliance
(see section 1).
Check and Insure the Existing External
Exhaust is
Clean (see section 1) and Meets Attached
Installation
Specifications
(see section 6).
Remove the Foam Shipping
Pads (see section 1).
Move the appliance
to the Desired
Location.
6 Level your appliance
(see section 8).
7 Connect the Gas Supply
(see section 3) and check for
leaks (see section 4).
Step 8 Connect the External
Exhaust (see section 7).
Step 9 Connect to plumbing
facilities
(see section 11).
Step 10 Connect the Power Supply
(see section 5).
Step 11 Check the Operation
of the Power Supply, Gas Con-
nections, and Venting.
Step 12 Place the Use & Care Guide
in a Location
Where
They Will Be Noticed
By the Owner.
For Alcove
or Closet Installation
see section 13.
For Bathroom
or Bedroom
Installation
see section 14.
For Mobile
or Manufactured
Home see section 12.
2O
Advertisement
