Agilent Technologies 3000 Series User's And Service Manual page 123

Table 8
Name
Selections:
• Edge
• Pulse Width
• Video
Maximum Input:
Trigger level range:
• Internal
• EXT
• EXT/5
Sensitivity:
• DC
• AC
• LF Reject
• HF Reject
Agilent 3000 Series Oscilloscopes User's Guide
Trigger System Characteristics (continued)
Typical Value
Trigger on a rising or falling edge of any source
Trigger when a positive-going or negative-going pulse is less
than, greater than, or equal to a specified value on any of the
source channels
Range: 20 ns to 10 s
Trigger on any analog channel for NTSC, PAL, or SECAM
broadcast standards on either positive or negative composite
video signals. Modes supported include Even Field, Odd Field,
all lines, or any line within a field.
CAT II 300 Vrms
±12 divisions from center screen
± 2.4 V
± 12 V
CH1, CH2: 1 div (DC to 10 MHz), 1.5 div (10 MHz to full
bandwidth)
EXT: 100 mV (DC to 10 MHz), 200 mV (10 MHz to full bandwidth)
EXT/5: 500 mV (DC to 10 MHz), 1 V (10 MHz to full bandwidth)
Same as DC at 50 Hz and above
Same as DC limits for frequencies above 100 kHz. Waveforms
below 8 kHz are attenuated
Same as DC limits for frequencies from DC to 10 kHz.
Frequencies above 150 kHz are attenuated
Specifications and Characteristics 7
123