Kenmore 116.21714 Use & Care Manual page 30

CHECK BAG indicator
activates.
Vacuum cleaner picks up
moveable rugs -or-
PawerMate pushes
too hard.
Cord won't rewind.
Vacuum cleaner leaves
marks on carpet.
Constant green light on
in dirt sensor.
No green or red dirt
sensor lights.
Red light for BELT
RESETis lit on the
PowerMate.
I. Full or clogged dust bag.
2. Dirty filters.
3. Blocked airflow passage.
4. Certain attachment tools.
I. Wrong height adjust setting.
2. Suction too strong.
I. Dirty power cord.
2. Cord jammed.
I. Wrong vacuuming pattern.
I. Dirt passage is clogged.
2. Lenses are dirty.
I. Switch not in CARPET position.
2. No power to sensor board.
I. Tripped belt reset in PowerMate.
I. Change bag. (page 21)
2. Change filters. (page 22-23)
3. Clear blockage from airflow
passage. (page 20)
4. This is normal. Light should go off
when tool is removed.
I. Adjust setting. (page 10, 13)
2. Select lower power Level. (page 11)
I. Clean the power cord.
2. Pull out cord and rewind. (page 10)
I. See VACUUMING TIPS (page 12).
I. Check for clogs in air passages.
(page 20)
2. Clean lenses. (page 27)
I. Move switch to CARPET position.
(page 11)
2. Take to your nearest Sears Service
Center.
Remove any items that may be
caught or jammed, then reset. If
vacuum cleaner starts and stops
again, clean agitator and end caps,
then reset. (page 19, 24-25)
Vacuum Cleaner Help Line:
1-877-531-7321
8:00am-5:OOpm EST, M-F
(U.S.A. and Canada)
- 30 -