Dirt Sensor - Kenmore 116.21714 Use & Care Manual

DIRT SENSOR
Although the dirt sensor feature in your
I<enmore PowerMate ® is designed for
years of trouble free use, the passage of
dirt through the air passage system can
coat the lenses causing the green light to
come on and stay on - never switching to
red. When this happens the lenses must
be cleaned,
CAUTION
_ _r[w__Never use water or any cleaning solution
when cleaning the lenses. The residue of
the water or cleaners will accelerate the
recoatlng of the lenses and make cleaning
TO CLEAN THE LENSES
1. Remove the wand from the PowerMate
by pressing the quick release pedal and
lifting up on the wand.
Wo nd
Quick
Release
Pedal--
2. As indicated by the illustration, the two
dirt sensor elements are located on the
inside of the swivel, approximately 4
inches/]O cm down, (note the arrows).
Each element should be cleaned periodi-
cally. To reach the sensor elements, use a
small brush such as a bottle brush. Brush
each sensor element several times to
remove dust and dirt.
Cross Section View
2. Reinstall the wand after cleaning the
sensors.
=27 =