Motor Safety Filter C Hanging; Hood And Tool Storage Cover Installation - Kenmore 116.21714 Use & Care Manual

MOTOR SAFETY FILTER C HANGING
The motor safety filter must be replaced when dirty. It should be replaced regularly
depending on use conditions. The motor safety filter CANNOT be washed as it will lose its
dust trapping ability.
NOTE: Use replacement motor safety filter STYLE CF-l, see part number detail in
REPLACEMENT PARTS (page 5).
WARNING
Electrical Shock Hazard
Turn off and unplug vacuum cleaner from
electrical outlet. Do not operate the
vacuum cleaner without the motor safety
filter. Be sure the filter is dry and properly
installed to prevent motor failure and/or
electrical shock.
1. Remove the dust bag as outlined in the
DUST BAG CHANGING section (page 21).
2. Lift the rubber retainer and pull out motor
safety filter as shown.
3. Replace the motor safety filter, white
side facing toward dust bag, by sliding it
back into place under the ribs in the bag
cavity. Tuck motor safety filter in so that it
fits completely under the rubber retainer.
\
4. Replace the dust bag as outlined in the
DUST BAG CHANGING section (page 21).
HOOD AND TOOL STORAGE COVER INSTALLATION
It is normal for the canister hood and tool
storage cover to come off when opened
further than needed. Line up the hinge slots,
insert the hinges into the slots, and close
the hood and tool storage cover to
reinstall.
- 22 -