Electrical Supply; Electrical Requirements & Wiring Diagram - Kenmore 153.331350 Use & Care Manual

Electrical Requirements & Wiring Diagram
Electric Shock Hazard
Disconnect power before
servicing.
Replace all parts and panels
before operating.
Failure to do so can result in
death or electrical shock,
Before plugging in the water heater, always make
sure:
• The voltage and frequency correspond to that
specified on the water heater wiring diagram.
• The electrical outlet has the proper overload
fuse or breaker protection.
1. The unit must be connected to a dedicated
power supply.
2. The unit must be connected to a 120VAC
power supply.
3. The water heater must be properly grounded.
4. This water heater is a polarity sensitive
appliance and will not operate if the power
supply polarity is reversed.
NOTE: Always reference the wiring diagram for the
correct electrical connections.
After making all electrical connections, completely
fill the tank with water and check all connections
for leaks. Open the nearest hot-water faucet and
let it run for 3 minutes to purge the water lines of
air and sediment and to ensure complete filling of
the tank. The electrical power may then be turned
on. Verify proper operation after servicing. See also
"Installation Checklist".
CAUTION: LABEL ALL WIRES PRIOR
TO DISCONNECTION WHEN SERVICING
CONTROLS. WIRING ERRORS CAN CAUSE
IMPROPER AND DANGEROUS OPERATION.
VERIFY PROPER OPERATION AFTER
SERVICING.
NOTE: Refer to the "installation checklist" before
operating this heater.
©n
© L1
_1_ EARTH GND
- CAPACITOR
© SLOWER
I I
I I
I I
I I
II1_11 C) FLAME SENSOR
@ HOT SURFACE IGNITER
(_ PRESSURE SWITCH
© HiGH LIMITSWITCH
(_) FLAMMABLEVAPOURSENSOR
Circled numbers indicate
sequence of operation.
Figure 43
42