Termination Clearances Sidewall Power Vent - Kenmore 153.331350 Use & Care Manual

Termination Clearances Sidewall Power Vent
\
\
\
\
\
/
[] Vent terminal
(_Air supply inlet
Area where terminal is not permitted.
'& -_ias meter/regulator
Figure 23
Vent terminal clearances for "Power Vent" installations.
Clearance above grade,
veranda, porch, deck or
balcony
Clearance to permanently
closed window
Clearance to unventilated soffit
Clearance to inside corner
Clearance to service regulator
vent outlet
Clearance to a mechanical air
supply inlet
,, Clearance underveranda,
................ porch, deck, or balcony
12 in. (300mm)
12 in. (300mm)*
12 in.(300mm)*
18 in.(457mm)*
3 ft. (0.91m)*
Power Vent configurations use room air for combustion.
Clearance to window or door that may be
opened
Vertical clearance to ventilated soffit located
above the terminal within a horizontal distance
of 2 ft. (610mm) from the center line of the
terminal
Clearanceto outsidecorner
Clearance to each side of center line extended
above meter/regulator assembly
Clearance to a non mechanical air supply inlet
into building or combustion air inlet to any other
appliance
3 ft. (0.91m)above
if within10 ft. (3m)
horizontally
12 in.(300mm)
Clearance above paved sidewalk or paved
driveway located on public property
4 ft. (1.2m)belowor to
side of opening;1ft.
(300mm)aboveopening
12 in. (300mm)*
2 ft. (600mm)*
N/A
4 ft. (1.2m)belowor to
side of opening;1foot
(300mm)aboveopening.
7ft. (2.13m)1
In accordance with the current ANSI Z223.1tNFPA 54, National Fuel Gas Code.
1 A vent shall not terminate directly above a sidewalk or paved driveway that is located between two single family dwellings and serves both
dwellings.
Permitted only if veranda, porch, deck, or balcony is fully open on a minimum of two sides beneath the floor.
* Clearance in accordance with local installation codes and the requirements of the gas supplier and the manufacturer's installation
instructions.
29