Grounding Instructions - Kenmore 790.3690 Series Use & Care Manual

Grounding instructions
For personal safety, the cooktop must be properly grounded. For
maximum safety, the power cord must be plugged into an electrical
outlet that is correctly polarized and properly grounded.
DO NOT Operate the cooktop using a 2-prong adapter or an extension
cord. If a 2-prong wall receptacle is the only available outlet, it is the
personal responsibility of the consumer to have it replaced with a
properly grounded 3-prong wall receptacle installed by a qualified
electrician.
See the INSTALLATION INSTRUCTIONS packaged with this cooktop
for complete installation and grounding instructions.
This appliance is equipped with a 3-prong grounding
plug for your protection against shock hazard and should be plugged
directly into a properly grounded receptacle. DO NOT cut or remove
the grounding prong from this plug.
Personal injury or death from electrical shock may
occur if the range is not installed by a qualified installer or electrician.
Grounding
type wall
receptacle
Do not, under any
circumstances, cut,
remove, or bypass
the grounding
prong.
Power supply cord with
3-prong grounding plug
Avoid fire hazard or electrical
shock. DO NOT use an adapter plug, an
extension cord, or remove grounding prong
from electrical power cord. Failure to follow this
warning can cause serious injury, fire or death.
Conversion to Liquefied Petroleum
This natural gas range is designed to allow for conversion
to Liquefied Petroleum (L.R) Gas.
Only a qualified service agent should perform the L. R
conversion. Contact the local gas provider for conversion.
The L. R Conversion Kit is supplied with this range and
is located on the main back of the range. The kit contains
installation instructions which must be read before and
followed carefully when installing the kit.
Gas (or L.P. Gas)
Personal injury or death from electrical shock
may occur if the range is not installed by a qualified installer
or electrician.
To avoid serious injury, any additions,
changes or conversions required in order for this appliance
to satisfactorily meet the application needs must be made by
a qualified service agent.