Kenmore 790.3690 Series Use & Care Manual page 35

General Care & Cleaning
Storage Drawer
Use the storage drawer for storing cooking utensils. The drawer can be
removed to facilitate cleaning under the range. Use care when handling the
drawer.
Removing and Replacing the Storage Drawer
To Remove the Drawer:
1. Open the drawer to the fully opened position.
2. Locate glide lever on each side of drawer; pull up on the left glide lever
and push down on the right glide lever (See Figure 1).
3. Pull the drawer away from the range.
To Replace the Drawer:
1. Align the glide ends on each side of the drawer with the glide slots on
the range.
2. Push the drawer into the range until the levers "click" (approximately 3
inches).
3. Pull the drawer open again to make sure the glides are properly seated.
Note: If you do not hear the levers "click" or the glides do not feel
seated, remove the drawer and repeat steps 1 and 2.
Left Glide
Pull up lever
with finger
Pull down lever .........................................................
with finger Right Glide
Figure 1
On some models an interior oven light will turn on automatically when the oven is opened.
The oven light may be turned on when the door is closed by using the oven light switch located on the Electronic Oven
control.
The oven light bulb is covered with a glass shield held in place by a wire holder. THIS GLASS SHIELD MUST ALWAYS
BE IN PLACE WHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
BE SURE OVEN IS COOL
i 1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. Press wire holder to one side to release glass shield, change bulb and be sure to replace
glass shield.
35