Selecting The Range - Agilent Technologies U1231A User Manual

Selecting the range

N O T E
U1231A/U1232A/U1233A User's Guide
The multimeter's selected range is always displayed above
the right- hand end of the bar graph, as the range indicator.
Pressing switches the multimeter between manual and
autoranging. It also cycles through the available multimeter
ranges when manual ranging is enabled.
Autoranging is convenient because the multimeter
automatically selects an appropriate range for sensing and
displaying each measurement. However, manual ranging
results in better performance, since the multimeter does not
have to determine which range to use for each measurement.
The range is fixed for diode tests, temperature, VZ
measurements.
In autorange, the multimeter selects the lowest range to
display the highest available precision (resolution) for the
input signal. If manual range is already enabled, press
for more than 1 second to enter the autoranging mode.
If autoranging is enabled, press
range mode.
Each additional press of
next higher range, unless it is already in the highest range,
at which point the range switches to the lowest range.
Introduction
Preparing Your Multimeter
, and AC/DC mV
LOW
to enter the manual
sets the multimeter to the
1
9