Wireless Communication; Connecting Peripherals - Panasonic CF-19 Series Reference Manual

Troubleshooting (Advanced)
Network
Cannot connect to network.
Cannot check the computer's MAC
address.
Wireless Communication (only for model with wireless LAN/Bluetooth/wireless
WAN)
Cannot connect to network.
Access point is not detected.

Connecting Peripherals

An error occurs while installing the
driver.
Set [Modem] to [Enable] in the [Advanced] menu of the Setup Utility (
60).
Follow the steps below.
Click [start] - [All Programs] - [Accessories] - [Command Prompt].
A
Input [ipconfig/all], and press Enter.
B
Write down the 12-digit string of alphanumeric displayed in the
C
"Physical Address" line of the LAN or the wireless LAN (only for model
with wireless LAN).
Input [exit], and press Enter.
D
Slide the wireless switch to turn on the wireless devices.
Set the devices ([Wireless LAN] / [Bluetooth] / [Wireless WAN]) to [Enable] in
the [Advanced] menu of the Setup Utility (
Restart the computer.
You cannot turn on wireless LAN if you uninstalled Display Rotation Tool.
To reinstall it, click [start] - [Run] and input [c:\util\disprot\Setup.exe], and click
[OK].
Confirm that / /
If / / is not displayed on the notification area, turn on the wireless
communication ( page 48).
When you install a driver of card or peripheral device, make sure that the driver
is compatible with the operating system. If it is not compatible, malfunction may
occur. For information about the driver, contact the manufacturer of the
peripheral device.
page 61).
is displayed on the notification area.
73
page