ProForm CROSSWALK 397 User Manual page 9

5. 5
Identify the Left and Right Handrails (59, 64).
Remove the four 5/16" x 3/4" Screws (5) and
four 5/16" Star Washers (6) from the bottoms
and sides of each Handrail.
Hold the Right Handrail (64) near the Right
Upright (76). Insert the wire tie on the Upright
Wire (63) through the hole in the bottom and pull
it out of the hole in the side of the Right Handrail
as shown. Then, pull the Upright Wire through
the Right Handrail.
Attach the Right Handrail (64) to the Right
Upright (76) with two of the 5/16" x 3/4" Screws
(5) and two of the 5/16" Star Washers (6) that
you just removed. Make sure not to pinch the
Upright Wire (63). Start both Screws, and
then tighten them.
Attach the Left Handrail (59) to the Left
Upright (66) as described above. Note: There
are no wires on the left side.
59
63
76
64
.
Position the Console Crossbar (61) between
the Left and Right Handrails (59, 64) with the
Console Ground Wire (47) positioned as shown.
Attach the Console Crossbar (61) to the Left and
Right Handrails (59, 64) with the other four 5/16"
x 3/4" Screws (5) and the other four 5/16" Star
Washers (6) that you removed in step 5. Start
all four Screws, and then tighten them.
6
47
61
64
9