Pin
Description
1
N/C
2
TXD
3
RXD
4
DSR
5
GND
6
N/C
7
CTS
8
RTS
9
N/C
Note: Signals referenced are for a DTE device. The HomeBase is at a right-angle to the printed circuit board (PCB).
Charging the Battery
The HomeBase powers the terminal and charges its battery pack in 4 hours.
The cradle knows when battery pack is fully charged and automatically changes to a trickle charge that keeps the battery at full
capacity. The terminal can stay in the HomeBase without damaging the terminal or battery packs.
Note: To check battery power, use Power menu setting; see
For more information about Li-ion batteries, see
To Power a Terminal and Charge its Battery
1. Install the battery pack in the terminal. Refer to
2. Connect the HomeBase to a power supply provided by Honeywell.
3. Put the terminal into the terminal well until the LED on the terminal turns red, indicating that it is charging. The battery pack
begins to charge.
12 - 4
5
4
3
2
1
9
8
7
6
Power
on page 7-13.
Battery Pack
on page 3-10.
Installing Battery Pack
on page 2-1.