KitchenAid Kitchen Aid KAR-19 Technical Education page 23

c) Slide the cutter grid forward and out of
the unit and place it on a work surface.
Be careful not to scratch the ice maker
liner.
d) Remove the spacer from the right cutter
grid bracket tab.
Cutter Grid
e) Unsnap the two ice guides from the
cutter grid tabs. There should be a
slight outward tilt after the guides are
installed. Bend the metal tabs outward
if necessary.
Cutter Grid
Ice Guides
8. To remove the evaporator thermistor:
a) Remove the cutter grid from the unit
(see step 7 on page 4-2 for the proce-
dure).
b) Disconnect the evaporator thermistor
connector from the bottom of the control
housing.
c) Remove the two hex-head mounting
screws from the water trough and pull
the trough from the unit.
Control Housing
Spacer
d) Reach behind the accumulator, and
unclip the evaporator thermistor from
the evaporator tubing and remove it.
Bottom Of The Evaporator
4-3
Evap Thermistor Connector
Water Trough Screws
Water Trough
Evaporator Thermistor
Continued on the next page.
Accumulator