3. REPLACING THE IMPORTANT PARTS
3.8 Replacing the Feed Button PC Board
1. Refer to section 3.1 to remove the top cover.
2. Remove the screws which fix the feed button PC board and the mylar sheet to the
mechanism.
B-EV4D model
Feed Button PC Board
3. Replace the feed button PC board with a new one, then reassemble in the reverse
order of removal.
4. After replacing, make sure the printer performs correctly for the following points.
• When the printer is turned on and then the top cover is opened, the status lamp gets
unlit.
• Next, when the top cover is closed, the status lamp lights up in green.
• When the [FEED] button is pressed during the unloading of a media, the status lamp
flashes in red.
B-EV4T model
3-19
(Revision Date: Mar. 27, 2009)
3.8 Replacing the Feed Button PC Board
T-3x6 Screw
Mylar Sheet
Top Cover
Mylar Sheet
EO18-33025