Toshiba B-SV4T SERIES Owner's Manual page 21

2. PRINTER SETUP
2.7 Loading the Media
(Cont.)
NOTE:
When the media is correctly set, the
backing paper is supposed to be
pinched by the Platen and the Strip
Feed Roller as shown below.
Strip Plate
Label
Strip Feed Roller
Backing Paper
Strip mode (Option):
When issued in the strip mode, labels are automatically removed from the
backing paper each time a label is printed.
• How to set the media
When issuing labels in the strip mode, set the label in the following
procedure:
1. Load the media as described on the previous pages.
2. Open the Strip Block by pulling it out.
Strip Block
3. Feed the paper through the Media Guide until it extends past the
platen.
4. Remove enough labels from the leading edge of the media to leave
about 200 mm of backing paper free.
5. Pass the backing paper over the Platen and the Strip Plate, and insert
the leading edge of the backing paper into the Backing Paper Slot.
Platen
6. Close the Strip Block and Top Cover.
Backing Paper Slot
Strip Plate
Platen
E2-10
ENGLISH VERSION EO1-33062
2.7 Loading the Media
Backing Paper
Strip Feed Roller