A1.3.2 Detection Area Of The Transmissive Sensor - Toshiba B-SV4T SERIES Owner's Manual

APPENDIX 1 SPECIFICATIONS
A1.3.1 Media Type (Cont.)
Item
Width including backing paper
Media width
Media pitch
Media length
Gap length
Black mark length
Thickness
Max. outer roll diameter
Roll direction
Inner core diameter
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC approved media.
2. When using a media roll of 76.2-mm (3") inner core diameter, the 3"-Diameter Media Shaft included in the
optional External Media Roll Hanger is required.

A1.3.2 Detection Area of the Transmissive Sensor

The Transmissive Sensor is positioned at 6 mm from the right edge of media.
The Transmissive Sensor detects a gap between labels, as illustrated below.
Sensor position
Min. 2 mm
(Min. 6 mm:
cut mode)
Issue mode
Batch mode
Label 12 to 609.6 (0.5 to 24.0)
Tag 10 to 609.6 (0.4 to 24.0)
10 to 607.6 (0.4 to 23.9)
Ø214 (8.4): When the optional External Media Roll Hanger is used.
Area to be detected.
Label
Gap
Label
Min. 8 mm
Strip mode
20 to 112 (0.8 to 4.4)
17 to 109 (0.7 to 4.3)
27.4 to 154.4
(1.1 to 6.1)
25.4 to 152.4
(1.1 to 6.0)
Min. 2 (0.08)
Min. 2 (0.08)
0.06 to 0.19 (0.002 to 0.007)
Ø127 (5)
Outside
25.4, 38.1, or 76.2 (1, 1.5, or 3)
EA1- 3
ENGLISH VERSION EO1-33062
Unit: mm (inch)
Cut mode
27.4 to 609.6
(1.1 to 24.0)
25.4 to 609.6
-----
(1.1 to 24.0)
25.4 to 607.6
(1.1 to 23.9)
Min. 6 (0.2)
(See NOTE 2.)
Sensor position
Print side
Media feed direction
6 mm
A1.3 Media