Before Installation - Bosch BC2600RA Installation Manual

3.

Before Installation

Check the Gas
• Check that the data plate (located inside of front cover) or
a temporary label (located on the front cover)
indicates the correct type of gas.
• Check that the gas supply line is sized for
178 MJ/hr for this unit.
• DO NOT OPERATE WITH ANY OTHER GAS TYPE.
Check the Power
• The power supply required is 240/230VAC, at 50Hz.
Using the incorrect voltage may result in fire or
electric shock.
Warning labels
• Located on the right side of the casing -PLEASE READ THESE LABELS CAREFULLY!
Use Extreme Caution if Using With a Solar Pre-Heater
• A solar transfer valve must be installed with all solar applications when using Bosch Eco 26+.
• Solar systems installed without a solar transfer valve will void all Bosch warranty.
Do Not Use Equipment for Purposes Other Than Those Specified
• Do not use for other than increasing the temperature of the water supply, as unexpected accidents
may occur as a result.
Check Water Supply Quality
• If the water supply is hard, acidic or otherwise impure, treat the water with approved methods in
order to ensure full warranty coverage.
4
Installation Instructions
WARNING
For NG Gas
CAUTION
BC2600RA
MODEL
GAS TYPE : NG
GAS CONSUMPTION : 178MJ/hr
HEAT OUTPUT : 45.7kW
ELECTRICAL RATING : AC240/230V 50Hz
RATED POWER : 56.0W
HOT WATER SUPPLY CAPACITY : 26L/min RAISED 25°C
GAS PRESSURE TEST POINT : MAX : 0.73kPa
: M I N : 0.18kPa
GAS SUPPLY PRESSURE MAX 3 0kP