Table of Contents
Advertisement
6.2
For your safety read before operating your
water heater
WARNING:
Explosion hazard!
▶ If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal
injury or loss of life.
A. This appliance is equipped with electronic ignition for
lighting the main burner. When turning the heater on, follow
these instructions exactly.
WHAT TO DO IF YOU SMELL GAS
▶ Turn off the gas shut-off valve.
▶ Open windows and doors.
▶ Do not try to light the appliance.
▶ Do not touch any electrical switch, telephone, and do not
use outlets.
▶ Extinguish all open flames. Do not smoke! Do not use
lighters!
▶ Warn all occupants of the building. Do not ring doorbells!
▶ If you can hear gas leaking, leave the building immediately.
▶ Prevent others from entering the building and notify the
police and fire department from outside the building.
▶ From outside the building, call the gas utility company and
a trained and certified installer.
B. Use only your hand to press the on/off control switch. Never
use tools. If control switch is jammed, close the gas supply and
call a qualified service technician. Forceful repair may result in
a fire or explosion.
C. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control which has been under water.
C 950/C 1050 (Pro TL 175 C/199 C) – 6 720 805 440 (2019/10)
6.3
Power
On
▶ To start the appliance press the On/Off button.
Fig. 60
Off
▶ To shut down the appliance press the On/Off button again.
6.4
Temperature selection
To select hot water temperature:
▶ Press buttons
+
or
temperature.
Fig. 61
Setting the water temperature
The desired temperature of the hot water can be adjusted on
the front control panel of the heater.
The water heater has an electronically controlled gas valve that
modulates the burner input in response to both varying hot
water flow rates and/or changes in any incoming and outgoing
water temperatures.
Note: The water heater, running at minimum BTU, may still
achieve temperatures above the desired set temperature. Low
flowing fixtures are the leading cause of this type of
temperature overshoot. To combat this symptom, clean
fixtures or replace with higher flowing ones if necessary.
Operation instructions
in order to reach desired
53
Advertisement
Table of Contents
