View Faulted Points; Bypass Points - Bosch D623 Series User Manual

.

View Faulted Points

To correctly turn your system on, all doors and
windows must be in the normal (not faulted) condition.
Use this command to locate faulted points.
1. Ensure the system is turned off (On indicator off).
2. Press [*]. If points are faulted the keypad displays
the following:
System OK
3. If there are faulted points, press [0] to view. The
keypad scrolls through all faulted points:
Pt2 faulted,
Front Door
To bypass Pt2
Press 2 + *
Pt7 faulted,
Back Door
To bypass Pt7
Press 7 + *
4. Return the faulted points to the normal condition
(like close the front door), or you may choose to
bypass the points by following the displayed
instructions (such as Press [2] [*]).
5. Once the points return to normal or are bypassed,
the system is ready to turn on.
Bosch Security Systems | 9/04 | 46841E
Point faulted,
or
Press 0 to view
D623 Series/D625 Series | User's Guide | View Faulted Points

Bypass Points

I can perform this command.
I cannot perform this command.
Use this command to bypass one or more points before
turning the system All On, Part On, or Part 2 On. You
can access a bypassed point when the system is armed
without activating an alarm.
Example: Your kitchen was just painted and you want
to leave the windows open but still turn the system on.
Bypassing points allows the system to be on, but
prevents it from monitoring undesired areas.
1. Ensure that the system is turned off (On indicator
is off).
2. Press the [BYPASS] key. The keypad may prompt
you to enter a valid passcode.
3. Enter your passcode if necessary. The keypad
scrolls all zones that can be bypassed:
Pt1,
Front Door
To bypass Pt1
Press 1 + *.
Pt2,
Back Door
To bypass Pt2
Press 2 + *.
4. Enter the Point Number that you want to bypass
followed by [*] (for example, if you want to bypass
Point 10, enter [1] [0] [*]). Repeat this step to
bypass all desired points.
If a point is already bypassed, the keypad displays:
Pt3
Hallway
To unbypass 3
Press 3 + *
If a point is faulted, the keypad displays the point
number. If the point is bypassable, the keypad
prompts you to press the point number followed
by the [*] key. If the point is unbypassable, the
display tells you the point cannot be bypassed.
5. Press [CMD] to exit this command function.
Press [CMD] to exit this command function.
15