Walk Test (Cmd 44); Reset The System (Cmd 47); Turn Watch On/Off (Cmd 61) - Bosch D623 Series User Manual

.

Walk Test (Cmd 44)

I can perform this command.
I cannot perform this command.
Use this command to walk-test detection devices
connected to your system. Perform the Walk Test on a
weekly basis. The types of devices that can be walk-
tested are configured by your security company.
1. Ensure the system is turned off (On indicator is off).
2. Press [CMD] [4] [4]. The keypad may prompt you
to enter a valid passcode.
3. Enter your passcode if necessary. The system starts
the walk test.
The keypad display scrolls all points one at a time
that need to be tested. To successfully test each
point, you must trigger the corresponding detection
device, such as reed switch or PIR).
Pt2 Un-Tested
Front Door.
Pt3 Un-Tested
Hallway.
Pt4 Un-Tested
Living Room.
To stop test
Press Cmd.
As each point is tested, the keypad display scrolls:
Pt2 Tested OK
Front Door
Pt3 Tested OK
Hallway
4. To stop testing, press [CMD].
Test fire detection devices (smoke/heat
detectors) weekly as instructed by your
security company and in accordance with
the devices' instructions.
Bosch Security Systems | 9/04 | 46841E
D623 Series/D625 Series | User's Guide | Walk Test (Cmd 44)

Reset the System (Cmd 47)

I can perform this command.
I cannot perform this command.
Use this command to reset the system (including fire
points) after an alarm. Detection devices, such as
smoke detectors and shock sensors, must be reset after
being activated. Resetting the system takes about 20
sec.
If points do not reset, contact your installing company
for help.
1. Ensure the system is turned off (On indicator is off).
2. Press [CMD] [4] [7]. The keypad may prompt you
to enter a valid passcode.
3. Enter your passcode if necessary. The system resets
and the keypad displays:
Resetting...
After the system has reset, the keypad display
automatically returns to the normal display.

Turn Watch On/Off (Cmd 61)

I can perform this command.
I cannot perform this command.
Use the Watch feature to "watch" points when the
system is off. For example, parents with small children
may want a tone to sound whenever a door or window
is opened as a way of monitoring the location of the
children.
Use this command to turn the watch feature on and off.
Once you have programmed the system with points to
watch and the responses (refer to Select Watch Tone
(Cmd 62) on page 24), you need to turn the watch
function on and off.
1. Ensure the system is turned off (On indicator is off).
2. Press [CMD] [6] [1]. The keypad may prompt you
to enter a valid passcode.
3. Enter your passcode if necessary. The keypad
displays the current Watch status (On or Off).
4. Press [1] to turn Watch On or press [2] to turn
Watch Off.
5. Press [CMD] to exit this feature.
23