Walk Test ? (Command + 4 + 4); Walk Test; Using Walk Test - Bosch D1260 User Manual

WALK TEST ? (COMMAND + 4 + 4)

Walk Test

Description
Use this function to test keypads, detection devices, and
sounders (both interior and exterior) to be certain they
function properly. You can review untested points at your
keypad to help pin-point any problems.
You cannot arm your system while in the walk test mode, and
no alarm reports are sent to your security company unless a
24-hour point is activated (such as fire or panic).
Upon initiation, the walk test will test the burglary bell pattern
on the bell output and ring the keypad burglary bell for two
seconds. The AC power is disabled for four minutes in order
to test the system's battery power.
Bosch Security Systems | 9/04 | 4998122475D
Security System | User's Guide | Part II: System Commands - WALK TEST ? (COMMAND + 4 + 4)
If the battery cannot maintain the system for the four-minute
period, the keypad will appear to go dead. If this happens,
contact your security company. At the end of the four-minute
period, AC is returned to the system and the control panel
restores. To test individual detection devices, simply activate
sensors and open protected doors and windows one-at-a-time.
As each detection device is faulted, the Keypad emits a brief
tone and the display indicates for 60 seconds that the point
has been tested. This verifies that each detection device is
working properly.

Using Walk Test

1. Ensure your keypad shows idle
disarmed text.
COMMAND
2. Press the key.
45