Powering Off The Projector - ViewSonic Pro10100 User Manual

Powering Off the Projector

1. Press the "Standby" button on the remote control or the
to turn off the projector 1. The following message will be displayed on
trol panel
the screen.
Press the "Standby" button on the remote control or the "
control panel again 1 to confirm otherwise the message will disappear after 15
seconds. When you press for the second time, the projector will shut down.
2. The cooling fans will complete the cooling cycle for about 60 seconds and the
POWER LED will flash Blue. The projector has entered standby mode.
If you wish to turn the projector back on, you must wait until the projector has
completed the cooling cycle and has entered standby mode. Once in standby
mode, simply press the "
or on the remote control to restart the projector. 2
3. Power off the switch 3.
4. Disconnect the power cord from the electrical outlet and from the projector.
Do not turn on the projector immediately following the power of procedure.
1
Sync
Shift
" button either on the control panel of the projector
Pattern
VGA
BNC
Sync
Exit
Menu
Source
Focus
Lamp PW
1
PIP
4
MyButton
7
RC ID
2
"
Power On
Standby
Video HDMI
S-Video DVI
Blank Source
Vol +
Mute
Vol -
LENS
Memory
Zoom Shift
RGB Gain Mode
2 3
Geo Blend
5 6
Keystone Aspect
8 9
Reset
0
20
" button on the con-
" button on the
3