Table of Contents
Advertisement
Installation
N
N
ote
ote
Contact the nearest
service center if the
projector displays
these symptoms. See
page 84 for more
information.
14
Powering Off the Projector
1. Press the
"
"
the panel
of the projector
button will display the following message on the screen.
Press the button again to confirm the shut down. If the button is not
pressed, the message will disappear in 5 seconds.
2. The Power LED flashes green (1 sec on, 1sec off) and the fans will
speed up during shut down cooling cycle. The projector reaches
stand-by mode as soon as the Power LED flashes green (2 sec on,
2 sec off).
If you wish to turn the projector back on, you must wait until the
projector has completed the cooling cycle and has entered standby
mode. Once in standby mode, simply press "
rear of the projector or "
projector.
3. Disconnect the power cord from the electrical outlet and the
projector only when the projector is in stand-by mode.
Warning Indicator
▀■
When the Lamp LED indicator lights red, the projector will
automatically shut itself down. Please contact your local
reseller or service center. See
▀■
When the Temp LED is on a steady (not flashing) red, the
projector will automatically shut itself down. Under normal
conditions, the projector can be switched on again after it
has cooled down. If the problem persists, you should contact
your local dealer or our service center. See
button on the remote control or
to turn off the projector. First push of
" on the remote control to restart the
page 64
"
"
button on
" button on the
.
.
page 64
Hide quick links:
Advertisement
Table of Contents
