Command
Config-URL
Revision
N
N
p For wide screen resolution (WXGA), the compatibility support is
ote
ote
dependent on Notebook/PC models.
p This AMX function is only to support AMX Device Discovery.
p The broadcast information only send out through valid interface.
p Both LAN and Wireless LAN interfaces could be supported at the same
time.
p If "Beacon Validator" was used. Please take care below information.
PJLink™ supported commands
The table below shows commands to control the projector using
the PJLink™ protocol.
Command Description Remark (Parameter)
Command
POWR
POWR?
INPT
Description
Device's IP address
LAN IP address is shown up if
LAN IP address is valid.
Wireless LAN IP address is
shown up if Wireless LAN IP
address is valid.
The revision must follow a major.
minor.micro scheme. The revision
is only increased if the command
protocol is modified.
Description
Power control
Inquiry about the
power state
INPT Input switching
Appendices
Remark (Parameter)
http://xxx.xxx.xxx.
xxx/index.html
1.0.0
Remark (Parameter)
0 = Standby
1 = Power on
0 = Standby
1 = Power on
2 = Cooling down
3 = Warming up
11 = VGA1
79