Removing The Camera Module; Replacing The Camera Module - Dell Inspiron 1764 Service Manual

Back to Contents Page
Camera Module
Dell™ Inspiron™ 1764 Service Manual
Removing the Camera Module
Replacing the Camera Module
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Camera Module
1. Follow the procedures in Before You
2. Remove the battery (see Removing the
3. Remove the display assembly (see
4. Remove the display bezel (see
5. Remove the display panel (see
6. Peel the camera module off the display cover.
7. Remove the tape that secures the camera cable to the camera module.
8. Disconnect the camera cable from the camera module.
1 display cover
3 camera module
5 camera cable
Replacing the Camera Module
1. Follow the procedures in Before You
2. Connect the camera cable to the connector on the camera module.
Begin.
Battery).
Removing the Display Assembly).
Removing the Display Bezel).
Removing the Display Panel).
2 alignment posts (2)
4 tape
Begin.
Removing the Battery) before working inside the