Display Bezel; Removing The Display Bezel; Replacing The Display Bezel - Dell Inspiron 1764 Service Manual

3. Replace the three screws that secure the display assembly to the computer base.
4. Connect the display cable to the connector on the system board, and replace the display cable grounding screw.
5. Route the Mini-Card antenna cables through the routing guides on the palm rest.
6. Thread the Mini-Card antenna cables through the slot in the computer base.
7. Turn the computer over and replace the two screws that secure the display assembly to the computer base.
8. Route and connect the Mini-Card antenna cables (see
9. Replace the keyboard (see
10. Replace the power button panel (see
11. Replace the module cover (see
12. Replace the optical drive (see
13. Replace the battery (see Replacing the
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Display Bezel

Removing the Display Bezel

CAUTION: The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.
1. Follow the procedures in Before You
2. Remove the display assembly (see
3. Carefully pull up around the inside edges of the display bezel to remove it from the display assembly.
1

display bezel

Replacing the Display Bezel

1. Follow the procedures in Before You
2. Ensure the display cable and Mini-Card antenna cables run through the notch on the left hinge to keep the cables clear of the display bezel.
step 5
Replacing the Keyboard).
Replacing the Power Button
Replacing the Module Cover).
Replacing the Optical Drive).
Battery).
Begin.
Removing the Display Assembly).
2 display assembly
Begin.
in Replacing the Mini-Card).
Panel).